Can unused cams of the BTL PA0400 bracket be removed?
The bracket is the same as for the BTL 6 AT variant.
It does not matter if cams are removed, as they are clamped in a different position.
_20230922093235.png)
Disclaimer
The technical information provided here free of charge in response to your inquiry is based on the knowledge available to BALLUFF and is intended to support you as effectively as possible in your technical question or application and to outline potential solutions.
As this technical information is provided free of charge, BALLUFF excludes liability for material defects and defects of title, unless there is intent or gross negligence on the part of BALLUFF or fraudulent intent. In this respect, BALLUFF shall only be liable for damages arising from defects in the technical information or from the breach of other contractual or non-contractual obligations in cases of intent or gross negligence. The above limitation of liability does not apply in cases of fraudulent intent, injury to life, body, or health, the assumption of a guarantee, or liability under the Product Liability Act. Any further liability of BALLUFF is excluded.
Before use in systems and machines, please check whether the information provided here free of charge is suitable for your application. By using the information provided here free of charge, you acknowledge these liability provisions.